General Preparation (3545)

General Preparation
  1.  Check that the computer is correctly docked (connected)  to the Dock I.
  2.  If possible, make sure that there are no hardware  conflicts settings, such as interrupt levels,  memory address, DMA channel, and I/O address.
  3.  Check that the SCSI ID is set correctly.
  4.  Test and correct any computer problem before you test  it with the Dock I. Use the computer documentation to  resolve any computer problems.
  5.  Test the computer with the external keyboard, external display,  mouse, and parallel and serial device connectors.  (Use the keyboard/mouse  connector to test the external keyboard and mouse.)  If no problems are found, connect the external keyboard,  mouse, parallel and serial devices to the Dock I, then  connect the Dock I to the computer and test it.
  6.  If external devices are attached to the Dock I,  such as an audio amplifier, check the device by referring to the  manual shipped with the device.
  7.  When the release/lock lever is opened with the computer docked  on the Dock I and power is on, a warning is indicated by a warning beep  and a LED message. If either do not work, the problem is in the LED  or the warning system.
  8.  If the user did not bring the computer with  the Dock I when service is needed,  use a computer that works correctly with the Dock I.
  9.  If a beep sounds when the computer is docked to the Dock I,  make sure that the following are correct.

     If the beep sounds during normal operation, dock the Dock I  to another computer and do the same operation again.  If the beep sounds, suspect a problem with the Dock I.

Back to  Jump to TOP-of-PAGE

Please see the LEGAL  -  Trademark notice.
Feel free - send a Email-NOTE  for any BUG on this page found - Thank you.